15320 Autoloader ALE: STEP : axis 2 communication error Trendsetter_400/800_Auto Remove the plate from the unload table and select the PLATE REMOVED button on the workstation dialog box. If the problem persists, then Creo Service should be called. This error occurs when there is a communications problem between the firmware and the stepper controller on the TEE-board. If the procedure described in Operator Action does not correct the problem, then the stepper controller must be re-initialized. Do this either by typing TABLE INIT or (if that does not work) resetting the recorder. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:01 2008 PST